Aqara Vibration Sensor

The Aqara Vibration Sensor can detect tilt, drop and vibration!

No, the Aqara Vibration Sensor must work alongside a Hub. When vibration is detected, it will trigger the Hub to make sound and light alarms. An alert notification will be sent to the phone or linked to control other smart accessories (via Automation).

The “vibration detected” event is triggered once a minute. If the event has been triggered, then it will not be triggered for the next minute. If the vibrations persist, the event will be repeated a minute later.

Due to the different materials, thickness, and structures of different objects, the same action or force applied to these objects will be recorded differently by the Vibration Sensor. Therefore, sometimes it is easy to trigger while other times not. You can increase or decrease the sensitivity of the Vibration Sensor through the Aqara Home app.

Open the app and enter the Vibration Sensor page. Click the “…” in the top right corner, then click “Adjust vibration sensitivity”. Next you can then choose the appropriate and desired sensitivity and then press “OK”. Finally, single press the reset button on the device to complete the set up according to the tips. If the set up fails, you can retry by following the same steps again.

The Aqara Vibration Sensor requires a CR2032 button battery. When changing the battery, insert a coin into the groove on the battery cover and turn it counter clockwise to release the cover. Remove the old battery and insert a new CR2032 button battery and tighten the battery cover. The Vibration sensor should then be working again.

After linking the Aqara Vibration Sensor to the Hub, press the reset button once on the Vibration Sensor at your desired location prior to installation. If you hear the Hub prompts “normal link confirmed”, then the location is suitable for installation. If you do not hear a voice prompt, adjust the location of the Vibration Sensor and try again.