Aqara Wireless Mini Switch T1

It supports single press, double press, and long press. These can signify different automations. It can control other smart devices with different actions.

The indoor environment requirements vary, and maximum signal strength between the Hub and the Aqara Wireless Switch is different, however you should ensure there are no more than 2 walls between the switch and the corresponding hub.

There are 3 possible reasons:

1. Operation error. Try to add the mini switch according to the adding method again.
2. The device is too far apart from the Hub. Try to move the device closer to the Hub, with as few obstacles as possible.
3. There are too many devices under the Hub.

There are 3 possible reasons:

1. If the device is too far apart from the Hub, Check the distance between the mini switch and the Hub and attempt to install the device closer to the Hub.
2. Low battery or no battery. You need to replace the battery.
3. The device is installed on the surface and the signal has been interfered with. Ensure you avoid metal surfaces.

1. Use the eject pin to push the reset hole of the wireless mini switch. If the Hub makes voice prompts, “Normal link confirmed”, it signifies that the Hub and the Wireless Switch are communicating properly. Go to ②; If there is no voice prompts, then move the switch closer to the Hub and try again. If there is still no voice prompt, the device might be deleted or run out of battery. Refer to the device adding methods to add the device or replace the battery.
2. Single press/double press/long press the Wireless Switch several times, enter the Home of Wireless Switch in app, refresh the device records (log). If there is related log, it indicates the device works properly.

1. Press and hold the reset hole on the device for 3 seconds. The indicator will flash 3 times before reverting to factory settings.
2. If a device needs to be paired with another device hub, it will need to be reset before the new pairing will succeed.